A Topside company - serving Whittier, CA

Before & After Gallery - Topside Attic Insulation Whittier

Insulation Before & After in Whittier, CA

We’ve insulated more than 9,000 homes since 2016, and every one of them left with a written price, a documented photo record, and, on air-sealing jobs, before-and-after blower-door numbers. This page shows what that work looks like in Whittier homes, from unsealed attics in Friendly Hills to rodent-damaged crawl spaces in East Whittier. The photos tell the story; the numbers back it up.

Call (424) 349-7262

Recent Transformations

Attic Air Sealing and Blown-In Insulation - Friendly Hills, Whittier

Before and after attic air sealing and blown-in insulation in Friendly Hills, Whittier
Attic air sealing and blown-in cellulose - Friendly Hills, Whittier

The homeowner had added insulation twice before, but the house still ran cold in January and hot in August. We found thermal bypasses everywhere: top plates gaping around chimney chases, can lights unsealed, a plumbing stack pulling conditioned air straight into the attic. Our crew sealed every penetration with fire-rated foam and acrylic sealant, then blew in GreenFiber cellulose to R-38. The blower-door test read 3,800 CFM50 before sealing and 1,900 after. The homeowner got the numbers, the photos, and a written scope under Haven Standard Clause 1.

Crawl Space Encapsulation and Vapor Barrier - East Whittier

Before and after crawl space encapsulation with vapor barrier in East Whittier
Crawl space encapsulation with 12-mil vapor barrier - East Whittier, Whittier

This 1954 ranch on Cole Road had a dirt crawl space that smelled like mildew every time the Santa Ana winds blew dry heat through Whittier. The fiberglass batts were hanging wet and black. We removed the damaged insulation, graded the soil, installed a 12-mil reinforced vapor barrier sealed to the walls with butyl tape, and closed the vents with rigid foam board. Relative humidity dropped from 78% to 49% within 72 hours. No more smell, no more soggy batts, and the floor above finally held temperature.

Spray Foam Insulation - Open-Cell on Knee Walls, West Whittier

Before and after open-cell spray foam insulation on knee walls in West Whittier
Open-cell spray foam on second-story knee walls - West Whittier

The second story of this West Whittier home was unusable in summer; the knee walls behind the finished space were bare drywall with R-13 batts that had slipped to the floor. We stripped the old material, applied 5.5 inches of Icynene open-cell spray foam for a continuous R-20 air barrier, and sealed the floor joist bays below. The blower-door reading improved by 1,400 CFM50. The homeowner told us the upstairs bedroom finally matched the thermostat setting - first time since they bought the place in 2019.

Radiant Barrier Installation - South Whittier, Unvented Attic

Before and after radiant barrier installation in unvented attic in South Whittier
Radiant barrier retrofit - South Whittier, unvented attic

A South Whittier homeowner called after their summer electric bill hit $480 running a 3-ton AC unit that couldn’t keep up. The attic was dark, unvented, and hitting 140 degrees by 2 PM. We installed an Owens Corning radiant barrier across the rafter bays, leaving a ¾-inch air gap for convective cooling, then added baffle vents at the eaves to create passive airflow. Attic temperature peaked at 108 the following August afternoon. The AC cycled normally, and the bill dropped 34% year-over-year. We documented the roof deck temperature readings in the photo record.

Insulation Removal and Replacement After Rodent Damage - Whittier Hills

Before and after insulation removal and replacement following rodent damage in Whittier Hills
Insulation removal, sanitization, and replacement - Whittier Hills

The Whittier Hills homeowner heard scratching for three weeks before calling. Roof rats had tunneled through 12 inches of old fiberglass, leaving compacted trails, droppings, and urine saturation across 60% of the attic floor. We suited up, removed all contaminated material, HEPA-vacuumed the deck, applied botanical sanitizer, and sealed every entry point with ¼-inch hardware cloth and copper mesh. Then we air-sealed and blew in new Knauf EcoFill cellulose to R-49. The photo record showed 47 images: before, during removal, sanitized deck, sealed penetrations, and finished insulation. Under Haven Standard, the written scope specified the rodent-proofing warranty separately from the insulation warranty.

Attic Cleaning and Full Envelope Seal - Central Whittier, 1926 Craftsman

Before and after attic cleaning and full envelope seal on 1926 Craftsman in Central Whittier
Attic cleaning and full envelope seal - 1926 Craftsman, Central Whittier

This Central Whittier Craftsman had original knob-and-tube wiring still active in the attic, horsehair plaster below, and decades of accumulated debris including disintegrated newspaper and a collapsed chimney flue liner. We coordinated with a licensed electrician to de-energize and abandon the old circuits, then cleaned the entire attic to bare decking, sealed the chimney chase with fire-rated materials, and installed Rockwool Comfortbatt around the chimney for ignition barrier compliance. The blower door started at 5,200 CFM50 - typical for a house this leaky - and finished at 2,400. The homeowner now heats the place with a single mini-split where they used to run a 100,000 BTU furnace.

What Every Job Includes

Professional blowing loose-fill insulation into an attic for energy efficiency
What Every Job Includes

Whether we’re sealing a 1,200-square-foot ranch in East Whittier or encapsulating a crawl space in Friendly Hills, the deliverables don’t change. You get a written price before any work starts - Haven Standard Clause 1, no exceptions. You get a named technician, background-checked and uniformed, with a text when they’re on the way. You get a Documented Photo Record on every visit, included, not available on request. On air-sealing jobs, you get before-and-after blower-door numbers - a pressurization reading that shows, in one figure, how much conditioned air your building envelope was losing before we started and how much it still loses after we’re done. And you get the 365-Day Done Right Promise: if it’s not done right, we make it right.

Materials come from Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, and GreenFiber. We don’t lock you into proprietary products. We specify what performs for your Whittier home’s specific conditions - coastal moisture influence, Santa Ana heat, 1940s balloon framing, or 1990s tract construction - and we put that specification in writing.

Need help today?Fast, friendly service and a no-obligation free estimate.

Call (424) 349-7262

What happens when you call

  1. 1
    A real person answersNo phone trees - you reach a local pro.
  2. 2
    You get an upfront price rangeHonest numbers before anyone is dispatched.
  3. 3
    A background-checked tech heads outLicensed & insured, dispatched right away.
  4. 4
    You approve before work beginsNothing starts until you say go.
BeforeBefore
AfterAfter

Want Results Like These?

Call (424) 349-7262 and a live person will answer, 24/7. We’ll schedule a free estimate, review any competing written quote with you at no charge, and give you a flat price in writing before anyone lifts a tool. Wes Okafor and the crew at Topside Attic Insulation Whittier have been sealing and insulating homes here since 2016. Let’s add yours to the count.

Written by Wes Okafor, Owner at Topside Attic Insulation Whittier, serving Whittier since 2016.

Need Insulation help in Whittier? Licensed & insured · same-day response · free estimates
Call (424) 349-7262
Local Service Coverage

Request a Free Estimate in Whittier

Tell us what you need - Topside Attic Insulation Whittier responds fast. No obligation.

When you submit this form, you agree to our Privacy Policy and consent to being contacted via phone, email, or SMS about your request, including by the independent contractors we may refer it to.

Prefer to text? Text Us
Call Now - 24/7 Dispatch